Tuesday, February 07, 2006

Gearbox continued

Following my post on G-boxx, I saw a gearbox prototype from Hayes showed in Interbike. It is made from a road bike cassette and a very simple derailler that push a pulley across the cassette. The design is good because it is simple stupid, much more simpler than a Rohloff hub. The good part is than standard parts are used here, simplifing replacement, which is a good departure form the geared hub gearboxes. However, this design puts a lot of load on the small chain, leading perhaps to breakage and wear. An overdesigned chain would be welcome here. The compangy said it is open for builders wanting to add the gearbox to their bikes. It is not probable than this design would be light enought for XC bikes, but it might be good for DH ones. The benefits are that

4 comments:

Anonymous said...

Are you a bicycle wheels enthusiast? If so here is a fantastic resource for everything related to biking and bicycle wheels with information, products, articles and more..Check it out here...http://www.natlbike.com

Anonymous said...

It's probably only putting about 3-7% more stress on the little chain... increasing length of chain does not decrease stress felt per link, but decreasing it does slightly decrease the number of teeth per sprocket that are engaged.

Anonymous said...

Hallo I absolutely adore your site. You have beautiful graphics I have ever seen.
»

Anonymous said...

Interesting website with a lot of resources and detailed explanations.
»